why is the vector group analysis done in transformer tests
Answer Posted / raju.t
1. To check the phase angle displacement between two
windings of a manufactured trafo.
2. To check the correctness of vector group mentioned in
the name plate of trafo and actual connection.
| Is This Answer Correct ? | 12 Yes | 1 No |
Post New Answer View All Answers
How we can defined theecopper cable size if we know the aluminium cable size?
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain
how to protect motor in dol starter having capacity of 30 hp.40 hp?
Why is a plain induction motor unsuitable for wide speed control?
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
What is lifting power for 1 wb/m2 and 1 A magnet?
in a simple IDMT relay we use neutral point of ct for earth fault then what is the requirement of neutral ct and cbct?
in conventional fan regulators how the current varies with speed?
How much load can take a 16 mm aluminum cable 3 phase
How to back charge the Gas turbine generator
How calculated single phase induction motor req. Capacitor?
What the formula for calculating no.of earthings & size of earth strip for 100mX90m shop.
what is magnetizing and demagnetizing current in generator and motor?