Interested to Buy Any Domain ? << Click Here >> for more details...
If the load of transformer is getting more than its
rating,,,than how to overcome this problem? Suppose thee
rating of transformer is 315kva and the load is going
beyond than the rating say around load: 352kva...
Than how can we solve this problem without deducting the
load.
- 14 Answers
- 23327 Views
- Hyundai, I also Faced
- E-Mail Answers
Answer Posted / v sridhar
in my view, whenever the load of a transformer is increased
there is a corresponding increase in its current as in our
case load is surpassing the rated value of the transformer
the current too will surpass the rated value causing the
load losses to increase beyond permiisible value causing
excessive heating of the coils, etc if this heat is not
dissipated quickly only then the problem of burning of
coils will arise, if by means of forced cooling etc we are
able to disssipate heat faster then the problem can be
solved to certain extent atleast the coils won't get burn.
Although the efficiency will go down as pointed out by
previous posts. Because in rural parts of india overloading
of distriution transformers is a very common phenomena...
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
Why ground terminal is used in pot meter 10k ohms
The electrical energy required to raise the tempreture of a given amount water is 200 kwh. If the heat losses are 20%, the energy required is?
what is the formula for calculating the phase clerance between two phases and phase to earth how to calculate the cable for a motor
hi this is hema, r there any books in particular for the preparation of the APPSC-A.E.E(electrical), if so please mail me the names ... thank u .
what is the importance of Partial Dischage test for Electrical Equipments
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
Dear sir, In our plant have Station Transformer having capacity,i want to know, why LV side 40 - 40MVA is given? & how we can get 6.3 KV supply from tertiary(i.e. Open delta connection), Vector Group YNyn0 - yn0 +d MVA Rating 80MVA / 40 - 40MVA + 26.7MVA Voltage rating 420 (Tap range +6,to -10)81.25% /11.5KV - 11.5KV +6.3KV
If we have use two power cable for incomer, that time how many use cbct for earth leakage protection? 1 or 2 if 1 way? If 2 way?
hi this is hema can anyone mail me previous years questions for the APPSC-A.E.E (in electrical stream.) ......thank u.
how to calculate micom relay earth falt time and current sertting
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
WHaT IS THE CONCEPT OF INDUCTION LAMPS IN MODERN LIGHTINGS, and HOW IT WORKS TO EMIT LIGHT ( AS NO ELECTRODES ARE PRESENT ) ?" COULD INDUCTION LAMPS CAUSE INTERFERENCE WITH COMUNICATIONS INTO A STORE USING INDUCTION LIGHTING ? WHAT IS THE BENEFIT OF USING THE LOW FREQENCY INDUCTION LAMP , VERSUS LED , AND VERSUS FLUORESCENT, AND VERSUS ANOTHER KIND OF LIGHTING . THANK yOU MOISES GUINDI
What conditions are required for transformer to operate at low frequencies ?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
