Interested to Buy Any Domain ? << Click Here >> for more details...
what is pf. how to calculate capacitor bank value to
maintain unity pf.
- 18 Answers
- 58948 Views
- JH, Saint Gobain, Supreme Treves, I also Faced
- E-Mail Answers
Answer Posted / hassan azzam
dear all your formula is correct but this for existing
system , wher if you dont have mesured value how to estimat
there use my estimation
Qc (Kvar) = connected load( kw)* 0.8 * 0.75 * 0.421
Qc (Kvar) = connected load (kw) * 0.2526
this is for future load or testing and commissioning perid
| Is This Answer Correct ? | 5 Yes | 10 No |
Post New Answer View All Answers
how power is generated,and transmitted to our home..pls explain briefly in simple words.
What is the effect of atmospheric pressure & Temp; on efficiency of motor? Why NGR(Neutral Grounding Resistor) is used in 132/11 KV Transformer & how? What is the use of Auto T/F in Grid Station?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
Use of switch mode power converter in real-time basis?
How earthing/grounding done in aeroplanes and ships.
Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???
What is the basic rule for block diagram reduction technique?
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.
Power factor =1.000 at factory in supply. However, PF = 0.8 at motor end. Current = 100 Amp, Voltage = 400 V. What is the power distribution loss? Can I reduce it by adding capacitor at the load feeder?
please explain to me how to calculate current,voltage,resistance with formula??
Can we check ELCB constantly from R1 to R8 phase in 1 no DB?
can the measured percentage error during calibration of single phase energy meter be negative?
by what factor the starting current is used when comparing star and delta connection for motor starting?
Name a govt approved university which have 100% online engineering course.
