What is the different type of class in CTS and why it is
required
- 2 Answers
- 5532 Views
- I also Faced
- E-Mail Answers
Answer Posted / vimal dixit
Measuring C.T.s - 0.2% class
Protection C.T.s - 5p10 class
AS in measuring cts accuracy of measurement is required.
While in protection cts only mesurement is required.
| Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
How to calculate Ith (I thermal) for curent transformer
Why is a plain induction motor unsuitable for wide speed control?
hi everybody how to design string combiner box (scb) internal parameters like bus bar and spd (surge protection device and fuse which place to set that,and also bus bar one particular cross sectional how much heat generated and how much power loss tell me Clearly and briefly
what is the use of power transformer in GSS.
why we use 630mm single core cable for transformer secondary side and why two neutral cable
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
1.what is the reason for transformer and lightning arrester blast in 33kv system
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
what is the ATS .And how it works.
How to calculate Voltage regulation of 22 KV Over head Line.
why star point of HT motor not earthed?
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What is meant by earthhing of a magnetic flow meter and when to use empty pipe detection?
How can we measure the residual voltage in dc machines?
How much load can be taken for chiller from 1500 kva transformer
