Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / naveen
Copper loss is the term often given to heat produced by
electrical currents in the conductors of transformer
windings, or other electrical devices.Since most of the
windings we see in practical application are of
copper,copper losses or winding losses are called copper losses.
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
what is the difference between the voltage of 5 volts capacitor and and 5volts battery?
what is the difference between torque induced and torque load?compare them with respect to dc motor?
what is the formula of starting current of 3phase and 1 phase motor???
what is the reason the main breaker is trip during the motor is running? (some time the breaker is not trip)
is there any current and voltage drop on liquid resistance starter water/soda tank ?
why power factor is important?
what is formula to cal cute earth pit numbers and size of earth strip used in earthing?
Hi I'm doing my MBA(3rd semester).I applied for the post of ET conducted by BHEL the last year.I cleared the written and lost in personal interview.Again I wrote the exam this time and cleared the written n yet to take the personal interview.Shall I disclose in the interview about my studies.What shall i say if they ask about my change from studies to job
I need HT sphere gap calibration table. Can any body help me.
Is it required to lay 2 runs of GI wires along with armoured cables from one power DB to another Power DB?
how synchronous condenser is used in place of synchronous generator with out negotiating IEEE standards? Can i use 3 generators as synchronous generators and 2 generators as a synchronous condensers in an IEEE 14 bus system with out disturbing the standards?
can indirect loading be called as phantom loading?
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
