Interested to Buy Any Domain ? << Click Here >> for more details...
Why TAP changer provided in primary side of HT
transformer ? and why not in secondary?
- 9 Answers
- 49141 Views
- ABB, Reliance, I also Faced
- E-Mail Answers
Answer Posted / s hubertsubis
if you provide tap changer on ht side we variy the voltage
as we required at secondary side if we connect in secondary
side we can variy the current as the changes in load
| Is This Answer Correct ? | 10 Yes | 31 No |
Post New Answer View All Answers
how can i improve the power factor in domestic (230v)
How isolater function when installed inelectrical 440V wiring
what is the meaning of osr in transformer.
in our all power plant have connected in grid and grid voltage and plant voltage is same, but as per as electrical concept the power will transmit from high potential to low potential but here altough same,then how power transmit from power plant to grid.
how 650 volts creates? where is use?
i have a 1500kVA transformer what is the kWH meter i need to use?
What is accuracy of a measurement?
Why the cores of large transformers build up of circular cross section?
Can Anyone Answer anyone of these ? Q1) why direct SOLUTION of Load Flow Studies in Not Possile ? Q2)Why majority of Buses in power system are load buses Q3)Why one of the buses in Power system is taken as reference bus (slack or swing) Bus ? Q4)Bus Admittance Matrix is a sparce (means it contains some zero elements ) matrix , give reason
what shall be no load voltage of 132/33 kV transformer ? is it 33 kv of 34.5 kV
What is pole of the system?
When we use 3 terminal resistor?
How to calculate impedance volt in Transformer?
What is force on parallel conductors ?
What about electrical Units. discrive in detail
