I am an electrical power engineer and arranged power system
for a data center, I installed MCB, ELCB and erthing system
TN-C-S.
But some times several ELCBs Disconnect circuits at the
same time! what may be the reason? (the ELCBs are 25A ,30mA)
Answer Posted / x man
TRY 100ma
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
explain which quantities change in the starting and the and the running condition in induction motor
How we can determine short circuiting current any plant and for example a plant which power generation is 415 volts and plant load is 500 kw.
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
Why the moulded plug comes with domestic appliances instead of assembled plug like anchor, Vinay 5/15 A.
how to select overload-relay for perticular motor 1.for D.O.L. starter 2. for Star-delta starter ????
What current flows in the transformer primary when its secondary is open?
bsec exam syllabus (mis)
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
What is phenomenon of electromagnetic induction and how it works?
how to decide the panel size like MDB ,SMDB PANEL SIZES
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
application s to shunt coil
PIU how does work?
what is magnetizing current test in power transformer