For what purpose an AVR in generator sensing generator
output voltage?and how the sensing is done by AVR?
- 3 Answers
- 8170 Views
- I also Faced
- E-Mail Answers
Answer Posted / jigs
To regulate the o/p voltage avr senses the gen o/p volt., a
pt is used to step down the gen o/p volt and then it gives
the proper volt signal to avr.
| Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
What is Primary And Secondary Injection Test of Relay and Other Electrical Devices. How IT is carried out.
How would your past experience translate into success in this job?
Different types of relay fault which phase sequence??
what is tri state logic gate
Which motor is 3.3 or 11kV more reliable, in terms of efficeancy,maintenance, reliability.
What is the difference between the relay and the circuit breaker?
what is high and low cut off voltage of BB and DG at SPS????????
what is the maximim current drawn by 1 phase and three phase welding machine
What should be the magnetic balance test values for a 3 phase delta/star connected single primary dual secondary winding transformer (90 MVA / 2 X 45 MVA TRANSFORMER)
Explain about retrofitting of machine tool.
What are the parts in a inverter?
can you send me the placement papers of electrical engg. from companis like NTPC,DRDO,IOCL,HPCL,BPCL etc.?If,plz send as soon as possible.Thanks.
orifice sizing how done, checking & selection
CAN ANYBODY PLEASE TELL ME HOW TO DESIGN A SERIES REACTOR FOR LIMITING SHORT CIRCUIT FAULT CURRENT??
What is the meaning of utility ground and clean ground? How the distribution panel is grounded?
