Interested to Buy Any Domain ? << Click Here >> for more details...
when the operation engineer told you that he gives the
control valve order to open but there is no response !
what will you do ?
and if you found that there is astuck , what will you do ?
(note : it is apanumatic valve )
- 5 Answers
- 7893 Views
- I also Faced
- E-Mail Answers
Answer Posted / maneesh
after doing all the priliminary inspection if u found the
valve is struck, u can directly give the air supply to the
actuator not:direct applying og air supply may diamage the
valve it should be done with sufficiant care.if the struck
is minor by repeaded giving of supply air will slowly
remove the struck.agfer this still its struck u can remove
the valve from the praocess line and chel the valve body
whether any solid material bloks the way.if that u can
clean and fix it back
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how to measure oxygen which methods are using?
Draw block digram for well head from well to shipping pump?
what effects a surging can produce in the compressor
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?
What is voltage regulator?
What is the cascade control
plz send me general of ongc
In Safe Guarding test what means by "Failed to Danger" ?
In most instances, Inertia processes are quite uncommon. Give an example of a combined Resistance and Capacitance situation.Describe an application, which according to your understanding of the subject matter, comprises of both Resistance and Capacitance effects.
how does we calibrate a square root flow transmitter ,give an example and explain it step by step like range calculation , calibration hook up series connection , zero check , and how to apply pressure , and if not geting proportional output then what should we do ?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
What are the type of bonnets in the control valves?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
Please any one can provide latest aptitude test,technical test and interview questions for tata consulting engineering (TCE) i need it asap thanks in advance
Why plc require in analog input 4-20amp & 0-10 volt?
