Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / pswin
It will depends on the type of magger. You can choose desire volt by using selector switch within the range of magger. For low voltage switchboard busbars, 500 V is enough.
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
In layman terms, what is the difference of Dielectric strength and dielectric constant when speaking of an insulating oil
What are marginally stable systems?
what are the stresses in circuit breakers ?
What is the differance between 2 dc motors of armature voltage 660 v and 440 v?
either water sensor or flow meter,how we observe the water level, f any other equipment are in market ?
why do we lay up the core of a cable?
What is gross error?
At full load wat is the motor p.f And at no load will is the motor p.f?
Explain in brief description about the operation of DG sets.
How will A Medium voltage circuit breaker(11 kV voltage level) operate under short circuit fault condition whether It is having short circuit release like Low voltage circuit breaker or relay should be given?
how we provide neutral earth on synchronising panel as per electrical standards?
How much ph is maintained of water resistance starter for slipring induction motor ?
why we cannot protect 100% winding of an alternator by using differential protection?
How capacitor improves pf
why constant voltage transformer should be start without load? and if started then what will happen?
