Interested to Buy Any Domain ? << Click Here >> for more details...
How to decide the input and output circuit breaker for a
1600kva transformer.Is there any calculation is involved.
- 5 Answers
- 11867 Views
- I also Faced
- E-Mail Answers
Answer Posted / baskaran.r
the high voltage side the rating will be according to fault
level of the system and primary current. the secondary
rating also according to the full load current of the
transformer
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
what is the preventive maintence for ht panels and busbars and vcb abd acb's.
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
High voltage test procedure of in swgr board. why should measure millivolt drop on testing time?
Wind mill
66kv under ground cable how to layaing in ground any special case two ckt r runing
What are Contactors? How they works and what its highest rating?
For a 6.6kV Motor it is recommended to do megger test with 500 V d.c and not more than 5kV d.c but the Hi voltage withstand test should be performed by 12kV AC. Why the dc voltage test should be limited but AC voltage withstand test could be with such a high voltage?
What is the method to solve circuit using source transformation?
what is EIB lighting control system? what is the advantages of this system?
Can you explain about Restricited earth fault protection scheme
how to calculate magnetic force genrated by a coil ?
Define conversion efficiency of a power amplifier. What is its value for class c power amplifier?
How can I calculate ISF of current transformer?
What is a fuse? How does it work? What are materials used?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
