Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ivy
Earth is a search current for dissipation
Neutral is the reference point for current also the return
path for current
| Is This Answer Correct ? | 16 Yes | 0 No |
Post New Answer View All Answers
What denotes the 5/8mm in the 3300XL 5/8mm proximitor probe?
why we are using magnet for calibration of gas detector?
what is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
What is the purpose of LO Overhead tank in turbines.
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
Why humidity limit is 30 to 55 % for raw material storage?
What is the cascade control
In turbine what does term CDP, NI, NH, HSSOC means.
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
what is instrument philosophy
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
Explain types of valves?
