Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bert
it is the comparison of two components from which the
primary is your standard (which is traceable to NATIONAL
INSTITUTE OF STANDARD AND TECHNOLOGY) and your secondary
component is the one to be calibrated.
| Is This Answer Correct ? | 14 Yes | 4 No |
Post New Answer View All Answers
How does your previous experience relate to the job you are applying for ?
How to calculate P,I&D value in PID controller ?
what effects a surging can produce in the compressor
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
What is furnace draft control?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
How we connect a instrument with ground, Give brief explanation with help of diagram?
I want to know about DDCMIS in detail ? please explain it. Also give name of reference books in which it is explained in detail in very simple manner.
while am calibrating Drager polytron 2IR flame gas detector occured non zero status.how can i get zero status?
Calibration procedure for electro magnetic flow meter
The Design Calculation of Level Transmitter For Different Structure open & Closed Vessel, Eg. Diff. Level Tx., Capacitance For Continous Operation
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
The company where I am working, their is rosemount 5400 series radar type level transmitter, it is meant to show level of filled tank, but along with the level it is showing temperature also, so my question is how a onon-contact type radar type level transmitter can show temperature even if it does not have any contact with the fluid?
Actual using of tube bender to bend 2 opposite 90 deg at correct measurement center to center of tubing.
why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V
