Interested to Buy Any Domain ? << Click Here >> for more details...
As per principle we say in three phase supply ,the voltage
is producing by phase angle between two phase so two phase
is needed means then why we using three phase ?
- 2 Answers
- 4316 Views
- I also Faced
- E-Mail Answers
Answer Posted / baskaran.r
in a given frame size we can get any number of phases but 3
phases are high in utilizing the capacity without much
complications. in a 3 phase system the phases are separated
by 120 degrees. in a two phase system the angle between them
will be 180 degrees which is the same as single phase only.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
How to select batteries required for ups and the inverter if we Known load? And how AH is selected of battery?
I am applying for NTPC examination.Can we please provide previous paper to my mail prasad.chintala108340@gmail.com
Should power factor be low or high?
i need project topics along with circuit diagram in the electrical and electronics engg and also some websites regarding projets.
Type of motor stater detail and working detail
how to commissioning the genset with amf panel?
What is meant by control system?
tan delta equation test on alternators
What do you mean by per capita requirement of electrical energy in india
What is the cut-off rate?
What's mean HVF & HAF in Vacuum Circuit Breaker?
why the frequency and voltage in india is 230v and 50HZ. when compared to USA say 110v and 60 HZ.
what is the meaning of vcc
Differentiate between real and apparent power?
