Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / hajhooj
when hv strikes ground it creat a voltage on the ground
mass around the point of the strike.this voltage is fading
as the point goes further from the point of strike.voltage
level at equal distance from the the center is equal.now
the step voltage is the difference in voltage between two
point which are located one meter apart from each other on
one line that is coming from the point of strike.
| Is This Answer Correct ? | 27 Yes | 1 No |
Post New Answer View All Answers
wheather the size of windings in motor and generator are the same
whatis the commertial spec. of distribution boards ?
What are the types of instrument transformer?
1.what is mean by 8/20 micro sec waveshape
When is lag lead compensator is required?
in HT service 3ph 4 wire service Y-phase voltage shows zero . whether it is meter fault? or what be the reason ? if y-ph voltage zero ,can current is recorded? reasons for failure?
How many types are using in 220kv/400 kv swith yard
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what is different between phase and netural
can anyone send me some sample question regarding power grid corp
As per the Anchor capstan motor specification, full load current is 200A. starting current is 1750 A and acceleration time is less than 8 seconds. Please guide for selection of cable size.
How to calculate mf when meter equipment and meter are connected
what is the pre charge circuit,what will be work which function it will be use plz tell me
What is Phase to Phase clearance for 800V System Operating Voltage as per IEC61439
what is calculation mathod/formaulla for deciding Size of busbar (Copper/ aluminum)for L.T. panel on Various Fault level like 50kA,25kA,10kA
