i have D.p. transmitter of range 0 to 2540 mmWC, i want to
use this for flow measurement (0 to 500 ltr/hr.) what
should i do?
- 9 Answers
- 22964 Views
- I also Faced
- E-Mail Answers
Answer Posted / raees mansoori
use this formula to dcs side Q=K*A*sqrt(H/P) or configured
sqrt output to transmitter side.
| Is This Answer Correct ? | 9 Yes | 1 No |
Post New Answer View All Answers
What is the working principle of the magnetic meter?
How to Calibrate Ultrasonic Level Transmitter in field
Whatis the reset ofset and control system in instrumentation
what is function of switch, and how is it work, explain with difination
Why is the orifice tab provided?
What is the basic difference between Modbus and CAN Open Protocols
Using your own examples solve a problem involving normal table. (experimental method and analysis)
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
in natural gas indirect water bath heater,how to prevent the problem of backfire from firetube during ignition...becoz of this backfire performance of wbh is going low.
I WANT SECURITY PAPER MILL, HOSHANGABAD TEST PAPER.KINDLY SEND TO MY MAIL ID
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
How you calibrate absolute pressure with the calibration range of 0 to 1000 0C Absolute. Please explain the procedure for calibration.
What is the function of solenoid valve in on/off & shutdown valve and why it is not used in control valve normally?
what step is taken for ESD ( emergency shut down) in DCS REPLY to hashimka20009@gmail.com
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
