why ELCB can't work if N input of ELCB do not connect to
ground?
- 5 Answers
- 23718 Views
- I also Faced
- E-Mail Answers
Answer Posted / chiss
Hi,all, i've got a problem with the understanding of ELCB,
may i know if only Red and yellow phase (2 wire of 3 phase)
connected to 4 pole ELCB? Does ELCB need a neutral to make
it work?
| Is This Answer Correct ? | 11 Yes | 3 No |
Post New Answer View All Answers
at which voltage level arcing ground is occurs ??????????
for 4 MVA , 33K.V/6.6K.V transformer. secondary side the connected load is 3000H.P. What is the rating of capacitor bank to be insttaled.
draw a circuit diagram connecting transformer OLTC- RTCC- VCB-Marshalling Box otherwise Explain in words
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
how braking & making capacity of circuit breaker is calculated?
why are u join ntpc
Define non-touching loop.
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
What is the transfer function?
Form S and "c" license application both are same? @ tneb portal
how 650 volts creates? where is use?
Why 15Amp. MCB is suitable to carry load of 1.5Ton Ac please Explain?
Is it possible to operate a synchronous 2-poles turbogenerator with a still-in-place faulted bar but electrically disconnected ???? If yes, should I act on the other phases as well ???
What is the formula to calculate the rating of a three phase air circuit breaker
A cylindrical wire is compressed in length by 10%. The percentage decrease in the resistance will be?????
