Interested to Buy Any Domain ? << Click Here >> for more details...
as an instrumentation engineer which are the things we have
to know / or we must have idea about that....
- 2 Answers
- 23668 Views
- I also Faced
- E-Mail Answers
Answer Posted / arun/ i&c design engineer
Instrumentation & Control engineering is the most
interesting and one of the most important engineering
stream in a process industry. Most of us have studied the
process of purifying petrol, diesel, kerosine from crude
oil, using distillation.....but for the right product with
right charateristics the process measurement is required in
real time for analysis and for a safe execution of the
same, the process should be under control. This basic
factor gives birth for the need of a engineering stream
called Instrumentation & Control.
so a instrumentation engineer must know about the basic
laws of physics, based on which each and every instrument
works, knowledge in electronics and microprocessors is must
to understand the modern day advanced measurement
techniques and control engineering. knowledge in
Matallaurgy and basic chemical properties will give u an
upperhand.
Konwledge on field instruments, basic electrical
engineering, wiring standards, control logic development,
control systems like DCS, PLC, communication protocols like
RS 232, 442 etc, profibus, control net, and upto the latest
foundation field bus concept, safty features, atleast
outerskin process knowledge...all these are required but
not limited to, for an Instrumentation engineer.
| Is This Answer Correct ? | 78 Yes | 6 No |
Post New Answer View All Answers
how pressurize drum calibrated ?
What is the diffrence between ff tx and non ff tx
Explain the working principle of lvdt?
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
the output of the common trasmitter protocol in qatar gas are the following
What is instrumentation instrumentation engineering?
Valve positioner and actuators in detail.
How many types of sensor
key exchanges in wpa,wpa2,tls
Describe the function of Accumulator into the Pump
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?
how to calibrate and troubleshooting of leveltroll?
What is shielding effect?
how to calibrate load cell
