What is the meaning of PASSIVE interface in RIP, IGRP, EIGRP
& OSPF??
Can any one explain..!!!
- 6 Answers
- 23314 Views
- I also Faced
- E-Mail Answers
Answer Posted / jitu
yes i know i [posted two question i know first one is too
hard for ccnaer but second one is in the sylbes of ccna but
know ,one is here for answer it
i can serch it one google or any wher else but posted soln
acts as a bacisc and fundamental.
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What are some standards supported by the Presentation layer?
What command do we give if router IOS is stuck?
What is the subnetmask of / 27 in network based and host based?
How does rip differs from igrp?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is the size of ipv4?
Explain what is formula of hold down time of eigrp protocol?
How many ways to access router?
What are segments?
How many types of ethernet?
Can you explain the basic of encryption in VPN?
What are partial updates?
Explain the difference between tftp and ftp application layer protocols?
What are the different types of the password used in securing a cisco router?
Which type of transmission bus topology support?
