Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE THUMBRULE FOR FINDING OUT THE CURRENT CAPICITY
OF A COPPER WIRE?? 2.5, 4, 6MM SQUARE ETC...
- 5 Answers
- 13219 Views
- I also Faced
- E-Mail Answers
Answer Posted / amro
depend the weathier out side the cabel
1- temperature
2- length of the cable
3-load factor
4- the cabel throw ( in air &duct & pipe &cabel tranch&
cabel leader inside the tranch)
for exampel:-
i= power/ volt* cos@
after that let used cabel 4 mm2
look in the catlog cabel and taking the rated current
oppset the wire
rated current *load factor*factor group*factor throw (in
air &duct & pipe &cabel tranch& cabel leader inside the
tranch )*factor temprature =current
1- if more then the load current ites ok
2- if less then the load current ites no must be chose the
big size cabel and again
calculate the equation and so an
after the calculate the voltge droop presentage must be
less the _+ 5 % from the main voltge
| Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
Define delay time.
Why are the cores of large transformers built up of circular transactions ?
Factory acceptance test. FAT. For 132 kv transmisstion towers what is that meaning and what are the tests commonly companies perform now days.
Can i use the B-curve MCB instead of C-curve MCB
why co incidence factor considered in transformer sizing?
what is the usage of microcontroller in the panel board?
Single line diagram for dbb (double bus bar)system.
What are the basic elements used for modeling mechanical translational system?
Two liquids hot and cold in two vessels are there and an metal bar acts as a conductor of heat between the two vessels. what happens then. what happens after 24 hrs?
what about GD square and its important for motor design?
How can ou verify the size of conductor 50Sq.mm ACSR
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
please suggest some good universities with low cost iam in totally full confusion so please help me my profile gre 283 and ielts 5.5
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
what is the use of static frequency converter and static excitation equipment? and where it is employed? for what?
