Interested to Buy Any Domain ? << Click Here >> for more details...
if AVR fails in alternator. what will be the effect.
- 13 Answers
- 28945 Views
- HP, I also Faced
- E-Mail Answers
Answer Posted / uma sanker dwivedi
GENERATOR WILL FAIL TO START AS THERE WILL NOT BE ANY
EXCITATION TO THE FIELD WINDINGS SO NO EMF WILL BE
GENERATED.
| Is This Answer Correct ? | 2 Yes | 4 No |
Post New Answer View All Answers
What difference between ref protection and differential protection ?
How to find ampere on ht side for selection of cable size ???
when we gave dc supply to 220v dc motor its rpm is 1200. then we gave 180v. how many rpm of its motor. gave answer with calculation at my ID.... ravizak@ymail.com
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
how to calculate the capacitor to maintain power factor?
What is reactive power and where it is used.
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
How much load can be taken for chiller from 1500 kva transformer
How the annunciator works ? How to do its wiring
what is effect of 5amp fuse on 2mva pry protection of transformer
I want to know how to calculate the size of electricity cable in building?
sir my exam is on 19/6/2013 under electrical branch pls send me sample aptitude questions as well as sample technical questions for jindal steel and power company
what is high and low cut off voltage of BB and DG at SPS????????
Sir 33kva 2 transformer load 900 amp calc 1800 amp mana jayega
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
