Interested to Buy Any Domain ? << Click Here >> for more details...
Do you know the faults occurs generally in motors and how
to rectify them?
- 4 Answers
- 13336 Views
- I also Faced
- E-Mail Answers
Answer Posted / shailza
general occuring faults in motor are:
1. inst. overcurrent
I(1)the current is equal to 8.5 times the nominal current
rectification-isolate breaker, take megger and check motor
T.B
2. Earth Fault I(0)
rectification-take megger
3. Stalling I1(t)
rectification- take no load trial with decoupling of motor
4. Thermal overload Ith
rectification- check current balance
5.phase imbalance I(2) Check motor T.B and take megger.
| Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
DRAW ACIRCUIT DIAGRAM OF 100 KVA 415V/55-0-55V DELTA TO STAR TRANSFORMER
The D.C. spark test is applicable to single conductor cable & assemblies of insulated single conductor cables without insulation shield,metallic sheath or metalic armor?
Please explain, how to test vector group of tranformer(Delta y1) . Thank
how ceiling fan worked?
Can a generator runs after getting 1st stator earth fault.
what is difference between bus coupler and auto transfer switch
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
i have flexible wire. size of conductors is 0.190 mm & no.of conductors are 48. then size of wire comes 1.37 sqmm instead of 1.5 sqmm . the what is tolerance for this size.
why should the lowest unit of a testing transformer ( cascaded transformer ) have higher power rating??
what reactive how to maintain
what is the benefit of floating our DC source? if i have two floating DC source of which 1 has a ref voltage of -21VDC and the other of -18VDC. can it be connected in parallel to share a common ref voltage? if not, how do i make both sources to be of common ref voltage? tks
Why we use auxillary relay ? what is function of differential relay, directional o/c relay?
why various test are performed on electrical panels & power cables before commissioning on site & what are these test???
If the feeder rating is 7.5 kw or 10 HP star-delta feeder, MCCB is taken as 63 a, contactors-32 a, how much will be the OLR rating or which range OLR should be considered when we concern about type-2 coordination?
difference between power surge and switching transient
