Interested to Buy Any Domain ? << Click Here >> for more details...
How we can calc. the Backup time of a battery Bank???
- 6 Answers
- 9726 Views
- Emerson, I also Faced
- E-Mail Answers
Answer Posted / thowsif_emerson_csm team
Hi Krishna,
V HV AN 65AH 32 No's of Batteries connected 60kva UPS,
What will be the full load backup time???
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
how to calculate short circuit current for the busbar
why the carbon brushes are broken in srim while the motor runningtime
1.What is the range of stator resistance of 3-phase induction motor? 2.Two electrically operated vibro motors are foxed in parallel direction in vibrating feeders. what is the direction of both vibro motors?
why can the rotor of 3 phase slip ring induction motor not be a 2 phase rotor?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
what will happen if there is a voltage leakage or current leakage in an electrical train
What is primary and backup protection?
What is gain margin?
is oil viscosity affect on motor current?
I'm looking for a softcopy manual set for a Credence ASL- 3000. Anyone know where I can get it?
can some one clearly explain why -48 volt DC use in telecom site????
what is the maintaining Cf in UPS.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
