Interested to Buy Any Domain ? << Click Here >> for more details...
In A.C systems, fuse is placed in phase-in order to
disconnect the circuit during faulty condition.
But, what is the reason for putting "LINK" in neutral
istead of connecting through (same) wire.
- 3 Answers
- 6093 Views
- I also Faced
- E-Mail Answers
Answer Posted / mritunjay singh yadav
neutral link is provided in neutral to protect the current
transformer from being the open circuit in faulty condition.
| Is This Answer Correct ? | 0 Yes | 4 No |
Post New Answer View All Answers
Dry type transformers
State The Difference Between Generator And Alternator?
how to find the Motor,s insulation Power?
How to checked frequency drive output voltages?
What is purpose of reactor?.What is different between line and bus reactor?
What is step signal?
cc of scorpio?
11kV capacitor bank of rating 2.4KVAR, is charged with protective relays of only over current & Earth fault &.......without Over Voltage, Under Voltage & Neutral Displacement Relay. Is it advisable??
What is value of earth resistance required for substation and equipment earthing and what are the reference guidelines
what is a pilot wiring and whys that called a pilot wiers
Grid fault level [KA]?
What do you mean by transformation ratio of instrument transformer?
Dear all i want to know SEWA Electrical Supervisor Licence test Previous Year Questions ? If any body know please send to me zohairaukllah@yahoo.com
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Why neutral point is consider as zero potential?
