Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / umang srivastava
its also use to represnt the waveform of any voltage or
current signal. Closer the value to 1.11 (for a sinousoidal
signal), better is the resemblence of the waveform with a
sinuosoidal signal.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
differnce between single acting and double acting solenoid valves
what is the role of transistor in Circuit?
what is gas turbine intercooling ?
What is the rating of circuit breaker needed for 300 KVA load in 33 KV supply line in a transformer of 33 KV / 415 Volt ?
How we can calculate the Amps for the cable Ex:- For 1sqmm wire how many amps we can draw (calculation)
what is meant by CT`s saturation ? Can we use Metering CT`s with Protetection CT`s ?
what are the applications of PLC?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
how does ELR works? explain
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
Do inductive loads have distorted current waveforms ?
Testing procedure of DG alternator stability test
is it possible to have dc motors on single chip
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
I want to design a heating coil of 80/20 nicrome for 3.5KW please give me the calculations choosing for physical dimensions assume coil voltage will be 110V AC assume necessary conditions
