Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE REASON FOR THE GROUND PIN IS BIGGER IN SIZE
COMPARING TO OTHER PINS?
- 13 Answers
- 16607 Views
- I also Faced
- E-Mail Answers
Answer Posted / venu
because as the diameter increases resistance decreases wen
ever a ground fault occurs by the body short of any
equipment it creates a very low resistance path to dicharge
through it
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
would the same effect be achieved by reversing the connection to one winding of the induction motor 3-phase?
If we have to find the inductance of a dc shunt motor then by giving dc supply or ac supply and what is the reason for it. (this example is from "to determine the transfer function of a dc shunt motor ")
what is Fan Control Cubicle
1.25 kg of hydrogen are burnt with stiochiometric air, the mass of air in kg required is
Instrument connected to a single phase supply
why only exciting current is shown not primary current in transformer???
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
how much winding resistance of 0.75kw to 12.5kw 3ph sqwiralcage induction motor?
which of the following elements is not present in stainless steel
What is dc current source? Differentiate between ideal and non ideal current sources?
Why do we perform an open-circuit test and short-circuit test on the transformer?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
How we can defined theecopper cable size if we know the aluminium cable size?
What is the rating factor for copper cable ( Specific value according to the type of laying ) & the voltage drop?
what parameters are should nessary for control technic dc drive(in rolling mills)?
