1. Why a DC motor starter is called 3 point starter
Answer Posted / rajeshwar kumar
dc motor starter is called 3 point starter it has three
terminal (L A F)(LINE,ARMATURE,FIELD) IT USED INSHUNT
MOTOR
Is This Answer Correct ? | 37 Yes | 14 No |
Post New Answer View All Answers
I AM A ELECTRICAL PANEL BOARD DESIGN ENGINEER.IF I GO ANY INTERVIEW ,TECHNICALLY WHAT ARE QUESTIONS I WILL FACE FROM INTERVIEWER?
Is it possible to obtain 480v or 550v in single phase output by giving the input to 230v to a single phase torodial type transformer without using a stepup transformer?
The transmission does not have options: a)Partition noise b) Flicker noise c) resistance d) Short noise and reason
what r substations?what r there work?why voltages r incresed and then reduced during distribution of power
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
What is an Air COmpressor
What is cable tray, its type, and its support?
Single line diagrams for star to delta and DOL starters.
state the working principle of incondenscent tube?
What is the maximum operating temperature for a thermoplastic insulated cable?
How to determine the breaking capacity such as break down current and break down voltage for VCB and CT's.
What current flows in the transformer primary when its secondary is open?
Define resonant peak?
When we connect the large capacitor bank in series ?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.