Interested to Buy Any Domain ? << Click Here >> for more details...
what is neutral ground resistance relay? how it is helpful
in protecting system?
- 5 Answers
- 9254 Views
- I also Faced
- E-Mail Answers
Answer Posted / ranjan prasad
Normally NGR is being connected with the neutral of
transformers or Generators to limit the the fault current.
This NGR basically gives the out put in terms of voltage
during the fault condition (like Earth Fault). To sens the
voltage during fault condition, isolation transformer is
connected across NGR for voltage feed back. This v f/b goes
to the relay to operate in case of earth fault depending
upon the setting done at relay.
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
WHY BREAKER ARE USED IN SUBSTATIONS?
sir, i'm preparing for hpcl exam officer trainee pls tell me how the exam ques paper pls pls
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
On 400 amp factory load how kvarh capacitors provide
how to find Harmonics and types as per the equipemnts
for 11KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV OH system what will be typical per KM "R" "L" "C" parameter. for 33KV UG system what will be typical per KM "R" "L" "C" parameter.
What is the meaning of floating point earthing in battery backed systems ?
Do you need any help with FEWA Electrical Supervisor exams?
What are unstable systems?
how to calculate the mesh earth network resistance in such substation, is there any recommended resistance values with references , thanks!
why we are not giving the zone 1 trip command to the master trip relay
What is the difference between acs 550 & acs 850
what is the min and max ohmic resistance for the earthing rod installed for lighting poles for street light network
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
why does make gain margin and phase margin on same plot.?
