Answer Posted / azhar
power factor can be improved by using phase advancer in
induction motor.
| Is This Answer Correct ? | 3 Yes | 10 No |
Post New Answer View All Answers
Draw the circuit of clapp oscillator?
how to design the heater in temperature control unit to heat 50KL of water?
how to avoid electrical shock how capacitor store charges wat are the speed control of induction motors state faradays law flemings left hand rule what is rotary converter wat is transmission and distribution what are the sources of energy abrevation of acb,vcb,sf6,igbt what is output equation of transformer which test copper iron and iron loss are calculated what is eddy current draw a single line diagram (10 marks) draw direct online starter(10 marks)
What will happen if the d.c. Shunt motor opened accidentally running on no-load has its shunt field winding?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
There are a trformer and an induction machine. Those two have the same supply. For which device the load current will be maximum? And why?
How to determine stage of Automatic Power factor controlling Relay(Apfcr)?
Is electro plating what type of load whether resistive, inductive or capacitive loads
Vaccum circuit breaker
What is meant by reactance voltage?
What is instrumental error?
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
What do you mean by a voltage transformer?