Interested to Buy Any Domain ? << Click Here >> for more details...
We operate a 10 Mw facility and we have been experiencing
several trips due to fluctuations on the MVAR? We have
checked all issues related to the AVR and we have found all
OK? Can anyone help us? The grid voltage, internal voltage,
all regular parameters look ok. MVAR fluctuate and there it
goes the unit? What could be happening? Thanks!
- 5 Answers
- 6789 Views
- I also Faced
- E-Mail Answers
Answer Posted / chaitanya
this may happen due to the variation of reactance produced
by the capacitors connected to that line/....isolate one by
one under observation...and this can be sorted out on
timely basis,,,,
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
what is the function of gss in the dg set.
I am using submission of two ct in one and half scheme for 67/67N protection. Both CTs star point is grounded separately near ct box.Will two point ground give wrong tripping to 67/67N during fault or no matter.
Why do we require transformer with less specific weight if supply frequency is increased?
what is physical distance of isolator to VCB in 33/11kv sub stations
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
Why collecting electrode of ESP to be earthed
why you don not show protection and type of isolation in key single line diagram?
there is an alternator 480 k.w, 400v,50hz, 4-wire running on load having leakage alternator body earthed current 38 A. is it within acceptable limit? if yes then give reference if no then how to bring within specified limit
How can you calculate the size of the down conductor cable for the lightning protection system. Is 70mm2 cable can replace 95mm 2 bare copper cable when the copper tape size is 25Wx3 thk mm.
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
what is the difference between the characteristics of two different phase bushing of any transformer
HOW TO CHECK THE VECTOR GROUP OF A TRANSFORMER YD11?
how does a liquid starter reduce the starting currents?
BSNL TTA EXAM QUESTION
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
