Interested to Buy Any Domain ? << Click Here >> for more details...
explain me how a power factor is improved by adding a
capacitor?what capacitor do to improve it?in simple words
and in detail?thx
- 7 Answers
- 12171 Views
- I also Faced
- E-Mail Answers
Answer Posted / ashish patel
My dear friend,
I m describing the answer very simply. If the load is
inductive load i.e. 100 Amp motor load. Then some current
i.e. 75% (75 A) will be drawn by Electricity line & balance
25% (25 A) will be drawn by Capacitors if they are connected
before load. so Electricity billing reduced only for 75 Amp
instead of 100 Amp.
I m using same system for transformer testing. So
technically we can say that we improve PF by using
capacitors, so that we get benifit in Electricity Billing.
If you want further clarification, plz write me on
ashish_patel111@yahoo.com
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
If a transformer primary winding operates at 240v, the secondary at 120v and the load is 1500w & the transformer is rated at 92% efficient, what's the current flowing through the primary winding of the transformer? What is the formula for finding this?
How to know of any cable size if there are not written on cabl?
how to calculate the loss tangent of electrical cables
help me with the question that might be ask on the interview for technical position
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
How to calculate the current of Highpressure Mercury Vapour Lamp?what is the basis?whether we have to consider power factor or not?
is there any chart showing the suitable cable size according to AMP and length ? for three phase motors
State ohm’s law?
can i use the six sigma method which is used in management area, in state estimation of power systems?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
Batteries used for electrical energy storage are a. Laclanche cells b. Edison cells c. Lead acid cells d.any of the above
explain with diagram how to protect transformers and substations from over current with help of CT's?
What are electric motors?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
what is ratio of copper wire size and current ?
