What is the function of Lightning Arrester & Wavetrap in
Power system ??
- 18 Answers
- 76431 Views
- ABB, Bhel, Energy Infratech, Infosys, NTPC, I also Faced
- E-Mail Answers
Answer Posted / trilok kumar (engr-electrical)
Lighting arrestors are used to protect the system from the
lightining surges/high voltage surges.
wave trap is a device that can remove, filter out or
exclude noise and interference from a wave, usually a radio
wave.
It may also be called a Rejector-circuit for radio systems
It is an electronic filtering device designed to exclude
unwanted signals or interference from a receiver.
| Is This Answer Correct ? | 16 Yes | 8 No |
Post New Answer View All Answers
what is the use of permanent magnet generator in exciter
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
Explain M Var? Which types of problem occurs when reactive power increase at the time of full load of plant and at the time of synchronize of plant?
whati s the sludge current in ups
what is the advantages of having in-built acvvvf (without seperate inverter in the control panel)in the drive system of elevators?
how many current required for hypo test
what are the advantages and disadvantages of oil filled cables over XLPE cables
what are the preventive maintanance actions taken for air circuit breaker? please answer me
how is the testing of an REF relay? what are the test REF circuit having?
IN dc capacitive reactance is??
can anyone explain the star-delta motor control wiring ,which wire go where and how they operate?
Ceiling Fan and Storage type water heater. Discuss
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
What is meant by Im=30mA@Vk/2. How to know the kee point voltage for CT design
what is smartµ grid technology?under coal gassification?
