Two electronic energy meters are connected to seperate
phase wires, but connected to a looped neutral. Are these
going to function correctly?
- 8 Answers
- 11279 Views
- DRDO, I also Faced
- E-Mail Answers
Answer Posted / thirumoorthy
It is assumed that it amounts to measurement of two phases
of power measurement by two single phase energy meters. Then
the meters will work satisfactorily but sum of two will not
give total power
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
What is the effect of pi controller on the system performance?
What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?
What is the function of NER and NET?
How many types of interlocking use in screw type air compressor,make-Kaser(BSD MODEL)?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
what is the step by step formula for calculating bus bar phase and neutral size of a panel board.suppose the incomer of panel board is 100A..???step by step answer please
Please define ohm’s law for a.c (alternating current)?
How can we calculate cable size in Low voltage & high voltage
Dear all: Recently we got a question about Interface between PMS and SAP-PM.once we got a update message from PMS.we should set the deletional flag for functional location in SAP system.Is there any FM or BAPI to use?There are only functional location create and change provided by SAP. Best regards!
what is the id1 & id2 setting in differential protection relay of CSPC?
what do you mean by plant earthing system.
WHAT IS SUBSTATION & ACCORDING TO VOLTAGE HT,EHT SUBSTATION EXPLAIN IT
Anyone who can recommend an equivalent to Envirotemp FR3 of Cooper?
Best way to measure the Soil resistance of rocky soil, three probe method and four probe method
What is Anemometer used to measure?
