Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / rajkumar
Any Txr has input, output, supply. give the simulated input
ie.. mA source or mV or pneumatic and check the o/p. if o/p
doesn't match adjust zero or span . Have details of range of
measurements in hand. In need use them also to get desired
output
| Is This Answer Correct ? | 6 Yes | 8 No |
Post New Answer View All Answers
basic connection and principle of axial shift sensor n differential sensors in tubine describes n draw......
can you send remote seal interface level transmitter calculation steps for oil water saperator.
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
what does it mean an active front end in vfd plz explain it briefly
can any one explain in which term we are flow flow is it volumetric r is it mass? and y
PT RTD Range: -200 to 500 degree celsius If I configured in DCS Lower range and Upper range . In face plate it shows red colour due to overa range how was the characteristics look If the temperature is more than operating range. how was the characteristics look . whether its in Resistance vs Temperature curve is Linear or Non linear
Why flow/pressure transmitter before control valve?
HOW CREATED LP & HP PRESURES IN DRUM FOR DRUM LEVEL MEASUREMENT!
in differential pressure transmitter,min&max pressure range for hp&lp
WHAT IS THE CAM POSITION IN CONTROL VALVE POSITIONER ? WHY IT IS USED?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
what is The specifications for oriface instalation
WHY THE DEGREE OF VALVE PLUG AND VALVE SEAT IS SLIGTLY DIFFERENT I CONTROL VALVE TRIM DESIGN
I m appointed as an automation trainee engineer in small firm in that I am only the one , my company give me a project on s7-200 as i m beginner I don't know how to program so please send me the helpful site so that I complete my project before deadline....please help me out in this critical situation.
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
