For testing 33kv cable hipot testing. How much kv we have to
Apply .Give in details.
- 24 Answers
- 97309 Views
- I also Faced
- E-Mail Answers
Answer Posted / sumit salunke
we are cheking only lekage current of cable
applicable value of voltage of 33 is should be 27kv dc
| Is This Answer Correct ? | 7 Yes | 28 No |
Post New Answer View All Answers
can i connect the two phases of scott connected transformer,if not why?
what are the application of over current relay?
A powerplant has 8 gensets operating in grid parallel mode. In one genset sometimes there is pf variation and kvar variation. The plant operates in pf mode. When this variation is observed the load is stable, voltage is also stable, freq and genset speed is also stable. How will you check the functioning of pf card. What shall be the ideal output vdc of the pfc, from there it is input to AVR?
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
what are the advantage and dis-advantage of 3 phase 4 wire energy meter?
Who many reason of ignition fail ?
we have amp, voltage, kw, length detail then how to calculte copper & alluminium size of conductor of 3-phase induction motor
what is ATS & RING MAIN UNIT in Distribution System?And its Function.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
Convert a star connected network into a delta connected network.
sir iam a 3rd yr eee student.no core company comes for recruitment to our college.my aim is to be placed in l and t.tell me the procedures.
In CTs tan delta point should be earthed , what is the reason behind it?
How to measure power in 2 or 4 or n phase circuit? Please give me a formula.
What is routh hurwitz stability criterion?
Its possible to use 3core 2R of 240 sq.mm cable for 3phases & separely 50sq.mm 3core cable fully for Neutral for connection of PCC to MCC 3ph..4wire system?
