Interested to Buy Any Domain ? << Click Here >> for more details...
why tan delta test conducted in electrical equipmenr
- 4 Answers
- 13029 Views
- I also Faced
- E-Mail Answers
Answer Posted / hardik vyas
TAN Delta test gives you the condition of the insulation
and also it helps in predicting that how long this
equipment can be in service. In short it gives you the
detoriation rate of insulation so you can predict the
remaining useful period of perticular euipment.
| Is This Answer Correct ? | 56 Yes | 4 No |
Post New Answer View All Answers
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
How to select the earthing transformer,for DELTA TO DELTA TRANSFORMER OR ALTERNATOR SIDE.Pls post your answers and calculation.
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
how to calculate current and voltage in a same circuit?
reason of diode failure in alternator
HOW DO I CALCULATE THE SETTINGS FOR THE DIFFERENTIAL PROTECTION OF A 12kV/6.6kV, 6MVA,DYN11 XMER WITH PRIMARY SIDE CTR 400/1 AND SEC SIDE CTR 600/1?
What is an ac motor?
What are the roles and responsibilities of electrical engineer in cement plant
When calculating the speed of a rotor required for a particular frequency of synchronous generator we use the equation 60f/p Is this p is the number of pole pairs of rotor & do we consider the number of pole pairs in the stator is 1?
what are the steps involved in generator load test?
WHAT SHOULD BE THE BEST CURRENT RATINGS (PRIMARY / SECONDARY)FOR A CT INSTALLED AT THE INCOMING 11KV PANE? WILL IT BE CALCULATED ON THE BASES OF MAXIMUM DEMANT VALUE OR ON SUM OF ALL TRANSFORMER'S KVA? NOMALLY MAX DEMAND REPRESENT THE MAXIMUM OPERATING LOAD OF THE PLANT AND TOTAL KVA OF (SAY 5 NUMBERS TRANSFORMERS) REPRESENT THE CONNECTED LOAD. WHICH i.e. MAX DEMAND KVA OR CONNECTED KVA ARE BETTER TO USE FOR CT CURRENT CALCULATION? PLEASE ANSWER.
What is the difference between a verilog task and a verilog function?
What willbe change in programming when we use 5/3 solenoid inplace of 5/2 in operating of a cylinder?
Whether the vacuum contactor requires Short circuit protection?If No,why?
33kv Rated output avilable in market (any where in india)
