A 3 phase motor, 440 voltage, induction motor. If we take
out rotor from motor and if we give supply 440 volt to
stator then what happens?????
Answer Posted / sony
i think it will burn due to increasing the air gap
Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
internally connection of photvoltic module
When we connect the large capacitor bank in series ?
How PADO software increase the efficiency of power plant?
What do you mean by passive circuit elements and why these are called passive?
what is spadar bar .why I use in DC generator.
why burdens of VTs is more than CTs?
how many joints are allowed in underground HT cable of 1 KM
why starting current is high and resistance is almost 0 during the starting of motor dc motor...?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
How could a garment factory benefit from renewable energy
Is neutral transformer can be called as control transformer?
why we use single core 630mm2 cable for transformer secondary side
According to underground cables a) stress b/w sheath & conductor is high b) inrush of core & conductor
How will you define capacitance?
What does quality factor depend on in resonance?