in the pipe line if the control valve fails to respond to
controller action,by what means we can stop the flow in the
pipe line ?
- 9 Answers
- 9553 Views
- I also Faced
- E-Mail Answers
Answer Posted / priya sharma
u can stop the air supply with the control valve accessory
that is the AIR LOCK
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
What is instrumentation technologists and mechanics?
what is wave length were using ?
If fire would be inside the plant which fire detector is to detected the fire.
Explain the difference between plc and cnc?
which type of signal used in instrument?
hey any one got the papers of SAIL and HPCL plz do help me by posting them to my mail ID's naren07_87@yaho.co.in, surenarendra@gmail.com
For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?
send me last 5 years questions asked in rrb chennai, for section engineer
What is the main difference between Cavitation and Flashing?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
how to convert cubic metre per hour to newton cubic metre per hour
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
Describe the function of Accumulator into the Pump
can we copy the software from a transmitter using hht(hart 275) ?
What is difference between “Fault Tolerant” & “Fault avoidance” PLC? Application where these system s are used?
