Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the size of cable for 100 kva load,?can
somebody tell me with a formula
- 7 Answers
- 61705 Views
- Havells, I also Faced
- E-Mail Answers
Answer Posted / venkatesh
1kva=1.7amps
100kva=170amps
firstfall we are find out cable item aluminium or copper
aluminium gives 1sqmm=1amp sand copper gives 1sqmm=2amps
but we can use more than 2amps beacuse cable long time will
not come.we have to select aluminium cable for 185sqmm
beacuse total load is 170amps 185sqmm is enoff
| Is This Answer Correct ? | 14 Yes | 22 No |
Post New Answer View All Answers
how do i commission a distribution transformer knowing all its ratings and transformation ratios?d
what is the solution for meger test failed the MV cable?
How does the phase sequence controller works, how it identifies the phases? confirm working principle
what is the question paper model for section engineer in RRB
what are carbondioxide and dcp used in fire extinguishers
what material is used in capaciter
I have 2500KVA transformer delta/star,13.8KV/380V provided with LV 4000A breaker. Already I have 2300KW motor feeder with a full load 90%. Is it possible to connect another 1600A from that breaker? If so how the calculation is done?
How to decide cable tray size?
Why colled 440V to 3-phase supply.
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what are the 4 rules to start the motor?
write down the formula of cable size in RM if current is 50Amp.
Name the component u would expect to find in a switchgear assembly?
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
