Interested to Buy Any Domain ? << Click Here >> for more details...
Why is the electric shock from the DC supply is more
dangerous than the shock from AC supply.
- 8 Answers
- 11953 Views
- IBM, I also Faced
- E-Mail Answers
Answer Posted / shivam
according to me...in ac , the wave is sinusoidal. the wave
goes to zero twice in one cycle. The person who got shock,
thus can be put away from the supply,,,,but in case of a dc
suppl,,, the supply is direct means wave is a straight
line, and doesnot go to zero anyhow.....thus dc is more
dangerous than ac
| Is This Answer Correct ? | 31 Yes | 2 No |
Post New Answer View All Answers
how to measure earth resistance of a substation
Earth leakage relay basic knowledge principle
Dry type transformers
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
How relay coordination has to be done? what are the inputs are required for this? Please explain this with calculation method?
The screw thread commonly used for transmission of motion is one of the following types of threads
How can get elongation of 2 k.G aluminium, if elongated aluminium dia is 2.5 mm?
On what basis do you decide the ONAN (Oil Natural air natural) or Dry type transformer for a project?
I HAVE A INCOMING 100A MCCB TPN 25KA, CABLE LENGHT OF 80M 70MM CABLE SIZE FROM MAIN SUBBOARD TO NEW DB.BASE ON THE FAULT LEVEL SETTING OF 45KA.I WOULD LIKE TO FIND OUT 25KA ENOUGH KA. APPRECIATE IF SOMEBODY CAN ASSIST ME WITH FORMULA FOR THIS. FRM: JEFF
Briefly describe means used by electricity suppliers to influence the flow of active and reactive power in power networks (one for each type)?
How to arrange a hous hold earthing system to keep minimum earth resistance( below 7ohms).
what do you mean by class PS CT and what are technical details needed for calculating it?
In the Variable Voltage Variable Frequency Drive, how the Voltage and Frequency varied ? Is it varied in the Inverter part of the Drive ? Please give us supporting document if any.
How does a tertiary winding filter harmonic(espcially 3rd one) from entering into load system?
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
