Interested to Buy Any Domain ? << Click Here >> for more details...
At site, we have 30Kw motor (3 phase, 400V,50Hz) and FLC
54A as per the nameplate. At the time of starting it draws
840A instead of 390A (7.2%). As per the data sheet also its
390A starting current. it thru a dol starter from the MCC.
can anyone tell what is the problem in the motor
- 5 Answers
- 11029 Views
- ME, I also Faced
- E-Mail Answers
Answer Posted / ranjan prasad
From the question motor terminal connection is not known.
However this problem may arise if you will connect the
motor in delta instead of star. First check the terminal
connection of motor, if it is in star, connect in the same
manner.
| Is This Answer Correct ? | 7 Yes | 3 No |
Post New Answer View All Answers
Explain the operation principle, advantages and disadvantages of the following converters: a) A 12 pulse converter b) A Switch-mode inverter c) A thyristor inverter
why ss stablity limit is more transient stablity limit?
i need of the bhel question papers along with answers and also give some website names for the downloading question (electrical and electronics engg question)please help me....
what happend to DC shunt motor if its field winding insulation becomes slightly weak? will that motor can run on full load or not explain in detail. thanks
Can we use BS 6651 and BS EN 62305 standards for computer room lightning ptotection in substation?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
i applied for the ap transco please forward the freqventley asked QA
why 1.7Uo for HV cable Hi pot test?IE standard why?
what is the working principle of energy saver control panel. please give the complete calculation & theory.
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
how to failure indution motor insulation & how to improve heat in motor insulation
Compare jfet’s and mosfet’s.
If there is major % of Voltage harmonics in the system, how can it be control or reduced?
what are all the components required to assemble solar panel other than pv cell?
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
