how many percent setting of motor over load relay of its
full load current
- 6 Answers
- 13530 Views
- I also Faced
- E-Mail Answers
Answer Posted / suresh
set the overload setting standerd draw currents 10% extra
but less than rated current
| Is This Answer Correct ? | 6 Yes | 9 No |
Post New Answer View All Answers
how to test YNyn0 vector group in transformer?
What do you mean by reach and reach the point of the relay?
what r the checklist while installing a 380 kva DG set
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
Please tell me the formulaes while designing a substation for power Calculations in designing a 33 KV Substation?????
what happen if the load connected to the induction motor is taken away? the same question for synchoronous generator in synch i think that the the exitation voltage will appear on the terminal only if so plz answer me
Can 33kva/415v transformer be run underground? If the answer is yes why and if the answer is no why?
can any tell me why slope 40% and 80% is calculated in differential protection?
What is meant by short-pitched winding?
What is minimum phase system?
What size cable (based on voltage drop) is required to supply a 40 A three phase boiler if the wiring system is 75V single insulated cables installed in non-metallic rigid conduit 56m from the main switchboard? Voltage drop in the consumer's mains is 8V.
What is Annunciation?
What current flows in the transformer primary when its secondary is open?
what the principle of sincroscope?how it works?when it needed?
Working of microwave oven?
