Interested to Buy Any Domain ? << Click Here >> for more details...
WHY IS THE SIZE OF HOLE OF THE EARTH POINT IN THE PLUG
POINT BIGGER THAN PHASE AND NEUTRAL
- 7 Answers
- 14701 Views
- Jindal, I also Faced
- E-Mail Answers
Answer Posted / kk_london
I will give u simple example, the tank containing water
with small tap and the other tank with same capacity of
tank and water with big tap. If we open the taps at the
same time the tank with the bigger tap will drain out first
same logic applies to size of hole of the earth point in
the plug.
| Is This Answer Correct ? | 3 Yes | 5 No |
Post New Answer View All Answers
could you measure current in parallel?
what is the diference between the 4pole & 6pole DC Motors & what is advantage 6pole over the 4pole ?
what is reactive power?, why its measured in VA ? is it transient behavior of system?
As we know induction squirrel cage motor torque Directly praprortinal to applied voltage in star connection & delta also. If I connect 55KW Motor to DOL starter in load condition does motor withstand the load & what will be the current withdrawn ? motor will not fail ?
should %impedance be high or low in a power transformer? if so why?
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
What is servo motor? what is its purpose?
What is the necessary and sufficient condition for stability.
how to calculate kvar in Akiva
we have 3 single phase transformers. how will we generate 6 supply from 3 phase supply input
Explain The Application Of Storage Batteries?
What is the name of transformers oil filteration equipment?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
Operation of isolators.
