Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between transmitter and converters?
- 9 Answers
- 34280 Views
- Videocon, I also Faced
- E-Mail Answers
Answer Posted / ankit sharma
transmitter used to convert physical signal into 4-20 mA or
0-10 V but convert convert pulse in form of digital signl
| Is This Answer Correct ? | 7 Yes | 9 No |
Post New Answer View All Answers
Hi my friends Is any one who can assist me in knowing the typical interview questions for system engineer at General Electric pty Ltd
how u calibrate pneumatic n motorized c/v?
Which types of quections asked in interview for FORMULATION PLANT (PHARMA)
how to measure oxygen which methods are using?
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
how we are selecting instuments by differentiating certain instruments in 4 to 20 ma range and certain in 1 to 5 v dc
can we replace a slot sensor (inductive type) with limit switch (potenial free contact / no-nc type).
Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram
how u calibrate sox nox co2 co in cemps?what is opacity n HPm?tell the standard parameters of cems?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
How to Calibrate Vibration Probe (Axial, Redial) in field
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
In turbine what does term CDP, NH, HSSOC means.
