Interested to Buy Any Domain ? << Click Here >> for more details...
If an induction motor is restarted before its rotor stop
rotating, then what will be the amount of current drawn?
Is this current will be the same as motor starting current?
- 5 Answers
- 7649 Views
- I also Faced
- E-Mail Answers
Answer Posted / lova subrahmanyam
in induction motor starting current is 3 times more than the
full load current at the time of starting.why because the
rotor is in stand still condition,(ie back emf of rotor is
'0').that's why to induce the emf in the rotor it takes more
current to produce the torque.onece the motor reaches the
rated speed it will take normal load current.if u cut off
the suupply
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
Application Comparison between 22KV (UE)and 33KV (E) system. Are we allowed to use 33KV (E) cable in lieu of 22KV (UE) cable. What are the technical disadvantages.
Which type of motor is used in trains, what is the rating of supply used explain working principal?
If i have two 3000 kW motors and the whole facility requires a 10 MVA transformer. What would be better installing two 5 MVA transformers(one for 1 motor ) or just a single 10 MVA transformer for both of them. Give reasons for your answer.
i have seen one 8.4 MW synchronous motor in a plant located in bellary it is fixed with brushless rotary rectifier ,anybody can explain its start up principle
what is the formula of starting current of 3phase and 1 phase motor???
how we decide the require size is this for a known current at fuu load?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
What is difference and reason b/w -48V BTS system and 24 V BTS system. Plzzzzzzzzz tel me.
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
how to calculate the formula of cable size if motor kw is given
What kinds of decision are made about CT from it's Knee point(voltage & current)?
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
why zero sequence impedance measurement is not applicable for single phase GT
why EMF IS INDUCED IN A CONDUCTOR WHEN FLUX LINKING WITH IT CHANGES ACCORDING TO FARADAYS LAW.
What are the components of feedback control system?
