Interested to Buy Any Domain ? << Click Here >> for more details...
what is the merz prodution ?
what is the turn to turn fault?
- 2 Answers
- 6654 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / mahboob
in high power generetor, stator has 2 windings in each
phase whic r connected in parallel. turn to turn fault
means short between these two windings in a single phase
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
Why induction motor is widely used in industry
difference between high and low impedance BUS BAR relay??
why co incidence factor considered in transformer sizing?
hello friend i wish to study a course related to the electrical construction, controlling and monitoring , which course i want to study? pls give me the name of institute?
what is the constructional difference between a power transformer and potentian transformer?
Ac generato how produce power I need for camplet defination
how to design step down 12 V, 1mA small transformer from 220 V AC? Because according to VI relation and power transfer it results bulky...
how to remover corona effect and hysteresis losses from contactor
Why does curving the pole faces in a dc machine contributes to a smoother dc output voltage from it?
ACB & VCB how do work and saftes and how can maintenance in this and parts name show with picture
Why efficiency of generator is higher than motor at a particular load?
Mention how NPN and PNP transistor works?
what is PDU in transformer?? which company manufacture??
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
Safety of on line ups
