parallel operation for tansformer which condition fill fil
for that
- 11 Answers
- 10006 Views
- ITC Infotech, Suzlon, I also Faced
- E-Mail Answers
Answer Posted / manoj tyagi
1. same voltage ratio
2. the per unit leakage impedence of the xer r based on
their own kva rating must be equal
3. ratio of eqv. leakage reactance to eqv. resitance should
be same for all the xers
4.transformer must be connected properly
| Is This Answer Correct ? | 2 Yes | 3 No |
Post New Answer View All Answers
what is 3rd Harmonics? how it is generated in alternator
what are the tests comes under the type test, what tests comes under routine tests.
what questions will be asked for 11/33KV licence interview APSEB hyderabad. Can any one share question and answers.
Can any one know what are the symbols at the down (below) the analog ammeter??? there are 4 symbols which are they ?????
What are approaches to tackle sedimentation problem of reservoir?
what is capacitor voltage transformer?? how it is different from potential transformer?
what is the difference b/w pvc cu conductor and cu breaded wire..?
I have motor 1500 HP and , 4160 V , 60 HZ , then i need the rating of transformer which can feed that motor ??
How can we findout the maximum efficiancy of Transformer? At which load?
please send me previous year questions of jspl through which i could prepare myself for the test.
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
how slip power recovery system work
completed BE & done apprentice at tneb & having experience 6 years. want to get c license. will apprentiship & BE be helpful for getting c license. will i get any preference by showing this?
surge tank, hrc fuse, earthing transformer, firm power objective type
