Interested to Buy Any Domain ? << Click Here >> for more details...
If I want to set a power plant in desert of ‘Rajasthan’ and
I have option of steam and gas power plant. Which plant I
should set up?
- 14 Answers
- 21015 Views
- DRDO, I also Faced
- E-Mail Answers
Answer Posted / harshad
hi pushkar plz dont do timepass here atleast!
| Is This Answer Correct ? | 10 Yes | 3 No |
Post New Answer View All Answers
What is the percentage of carbon present in pig iron?
How is the gear ratio calculated?
what is Retainer?
what is the exams to be conducted for mechanical engineers and then how to prepare that
Explain mechanical refrigeration.
Define the terms free energy and free enthalpy. What is their significance and importance ?
why viscosity is measured in kinematic viscosity.?
what is the actual difference between casting and moulding? explain pressure die casting process?
What can be reasons for a metal gas-kit to leak?
Why would some industries select pneumatics over hydraulic?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
what is the use of vacuum balancing valve in CEP
send me vizagsteel papers (m.t.. please.)
What are good characteristics of good combustion in a boiler?
Why must we pay attention when we drain steam in steam turbine. What factors are observed?
