What is the selection & Designing procedure for
DG/Transformer
- 4 Answers
- 9148 Views
- Crompton Greaves, Sterling, TATA, I also Faced
- E-Mail Answers
Answer Posted / ramarpandi
rating
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
For small size, high frequency coils, the most common core material is- a. )Air b. )Ferrite c.) Powdered ion d.) Steel
what will be the min and max voltage flow from neutral to earth?
Is there any rule to select the voltage of motor based on KW rating? What is the rating above which lt motor becomes the HT motor?.
Why is voltage is required to be within permissible range for an electrical equipment?
In Power cable specification what is U0/U and Um.
why steady state stability limit is greater than transient stability limit ? How it can be explained ?
how we design a pannel to start 10HP motor with the help of star delta starter?
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
What does the term supermesh means?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
What will be the fault current of any system when its generation is 10% of BASE generation( FUll Load )?Will is 10% or the same as full base calculation?
difference between semiconductor & conductor & insulator?
In single phase capacitor motor, if the motor rotate reverse direction then how much power will be consumed by the motor and why?
