HOW THE ORIFICE & PRV SIZING BE HAPPENED -- EXPLAIN IN BRIEF
- 3 Answers
- 6931 Views
- I also Faced
- E-Mail Answers
Answer Posted / ankit
0.68 x d where d= dia. of pipe
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
what is piezoelectric transducer?give an example in power plant n state its principle?
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
in mass flow meter what is drive friquancy ?
What is the difference between modbus,fieldbus & profibus
How process line mpm calculation is done?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
How it the difference between force balance system and dispalacement balance system?
what are the values of fuel flow rate in various places in boiler.
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
give me all the details about the interview and which type of question being asked
we are having yokogawa centum cs3000 dcs in our power plant. i need some of the operator guides NOT to appear in HIS0163 AND HIS 0162 but it shoul appear in HIS0164 HOW TO DO IT?
what is the reset offset and control system in instrumentation
How can measure flow in oil line?which type of transmitter is generally used?
hello sir/madam, I,Subramanian need 5yrs placement papers of officer trainee of Instrumentation technology.pls send to this mail id mani_nxtgen@yahoo.co.in please do the needful. with regards, subramanian.v
what is vibration a part of proceess variable? if vibration is a part variables then how we minimize the actual vibration on machine on load,? vision of instrumentation contrl plz ans me IPGDL interview question
